Wisconsin WisDOT DMV CDL General Knowledge Practice Test 7
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. What should a driver assume about the height posted at a bridge or an overpass?
Show answer
Answer B: That it may be wrong, because repaving or packed snow can leave less clearance than the sign shows
Resurfacing and packed snow raise the road under the structure, so the real clearance can be lower than the posted figure.
-
2. Why should high beams not be used in fog?
Show answer
Answer A: The light reflects back off the droplets and blinds you
Fog is made of water droplets that scatter light straight back at the driver, so a stronger beam makes the wall of glare worse rather than better.
-
3. You are hauling an open box of loose gravel. What does that load require?
Show answer
Answer A: A cover, so that material cannot blow off or spill onto the road
Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.
-
4. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
5. A commercial vehicle stops on the shoulder of an undivided two-lane road that carries traffic in both directions. Where do the warning devices go?
Show answer
Answer B: Within 10 feet of the vehicle, plus 100 feet to the front and 100 feet to the rear
On a two-way road the devices must mark the vehicle itself and warn traffic approaching from each direction, and they must be in place within ten minutes.
-
6. How long must a motor carrier keep a driver vehicle inspection report and the certification of repairs?
Show answer
Answer B: Three months
The original report and the certifications attached to it are kept on file for three months from the date the report was prepared.
-
7. How does a front tire failure usually feel to the driver?
Show answer
Answer D: The steering suddenly becomes heavy and pulls to one side
A failed front tire loads the steering and makes the wheel feel heavy, while a rear tire failure shows up as the back end swaying.
-
8. You must drive well below the speed of surrounding traffic, for example when climbing a steep grade with a heavy load. What should you do?
Show answer
Answer B: Turn on the four-way flashers to warn following traffic, where state law allows it
Flashers warn faster traffic that a slow-moving vehicle is ahead, which helps prevent rear-end crashes; some states restrict their use while moving, so check the local rule.
-
9. How many questions does the Wisconsin air brakes test have?
Show answer
Answer D: 25 questions
Wisconsin uses a 25 question test drawn from section 5 of the Commercial Driver's Manual to remove the air brakes restriction.
-
10. You press on a drive belt and it deflects far more than the others. What does that suggest?
Show answer
Answer C: The belt is too loose and the part it drives may not work properly
A belt with excessive play slips on its pulleys, so the accessory it drives turns too slowly or not at all under load.
-
11. What information does an inspection decal on a commercial vehicle carry?
Show answer
Answer B: The date of the inspection, where the inspection report is kept, and information identifying the vehicle
The decal shows when the inspection was done, the name and address of the entity that holds the inspection report, and which vehicle it belongs to, so an officer can confirm the inspection at a glance.
-
12. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
13. Which wheel or rim condition must be treated as a defect during the walkaround?
Show answer
Answer C: Cracks, illegal welded repairs, or missing and loose lug nuts
Cracked or welded rims and missing or loose fasteners can let a wheel separate from the vehicle and must be corrected before driving.
-
14. During a right turn in a tractor-trailer, what are you looking for in the right hand mirror?
Show answer
Answer B: Whether the trailer will clear the curb and whether anything has moved alongside you
The right mirror is what tells you how close the trailer wheels are running to the curb and whether a vehicle or a cyclist has slipped into the space on your right.
-
15. After starting the engine, how quickly should the oil pressure gauge come up to its normal range?
Show answer
Answer B: Within a few seconds
Oil pressure should build within seconds of starting; if it stays low, the engine is not being lubricated and should be shut down.
-
16. Where on the road are you most likely to find ice in cold weather?
Show answer
Answer B: On bridges, overpasses and shaded stretches, which freeze before the rest of the road
Bridges and overpasses lose heat from above and below, and shaded areas get no sun, so they ice over first and stay icy longest.
-
17. How do objects appear in a convex mirror compared with a flat mirror?
Show answer
Answer B: Smaller and farther away than they really are, while a wider area is shown
A convex mirror shows a wider field but shrinks everything in it, so the driver must remember that vehicles are closer than they look.
-
18. On a scale, your loaded truck is well under the gross weight limit, but one axle is above the limit for that axle. What does this mean?
Show answer
Answer D: The vehicle is overloaded and the load must be shifted or reduced before you drive on
Each axle and axle group has its own limit and each must be respected; being under the gross limit does not excuse an overloaded axle.
-
19. Who may remove an out-of-service sticker from a commercial vehicle?
Show answer
Answer B: Only an authorized person, and only after the defect that caused it has been repaired
The sticker stays on the vehicle until the repairs are made and an authorized person removes it, so nobody can simply peel it off and drive away.
-
20. Which road users are hardest to see at night?
Show answer
Answer C: Pedestrians and cyclists in dark clothing
People on foot or on a bicycle carry no lights of their own in many cases, so they appear only when the headlights reach them.
-
21. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
22. The rear wheels of your vehicle lock during braking and the rear starts to slide sideways. What should you do first?
Show answer
Answer A: Stop braking so the rear wheels can roll again, then steer quickly in the direction you want to go
Locked wheels have no side grip; releasing the brakes restores traction and then countersteering brings the vehicle back into line.
-
23. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
24. You are backing into a yard where electrical wires cross overhead. What is the main concern?
Show answer
Answer C: The wires may hang lower than the top of your vehicle
Overhead space has to be checked like any other space around the vehicle, because wires and cables are often lower than they look from the cab.
-
25. What is wrong with resting your foot on the clutch pedal between shifts?
Show answer
Answer B: It slowly wears the clutch out, because the pressure plate is never fully engaged
Any weight on the pedal partly disengages the clutch, so it slips and wears; the foot belongs off the pedal once the shift is finished.
-
26. You are taking a tightly curved highway exit ramp in a long combination. Where should the tractor be placed within the lane?
Show answer
Answer D: Toward the outside of the curve, leaving room for the trailer to track inside
Because the trailer wheels cut to the inside of the curve, the tractor has to be kept out toward the outer edge so the trailer does not drop a wheel off the inside edge.
-
27. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.
-
28. Why do cracked spring hangers or badly worn shackles matter?
Show answer
Answer A: They allow the axle to shift out of its correct position under the vehicle
Hangers and shackles hold the spring, and therefore the axle, in place, so when they fail the axle can move and the vehicle may become uncontrollable.
-
29. What are the rules for using your turn signal before a turn or lane change?
Show answer
Answer A: Signal early, keep the signal on until the turn is finished, then cancel it
An early, continuous signal tells others what you plan to do; cancelling afterward keeps the signal from misleading them.
-
30. What are you looking for when you check the hubs and wheel seals during the walkaround?
Show answer
Answer B: Leaking oil or grease, which can also contaminate the brake linings
A leaking hub seal starves the bearing of lubricant and the escaping oil or grease can soak the brake linings and cut braking power.
-
31. When should a driver add space beyond the basic following distance rule?
Show answer
Answer D: On slippery roads and whenever visibility is poor
The seconds rule is a minimum for good conditions, so rain, snow, darkness and heavy traffic all call for more space than that.
-
32. On a multilane highway, which lane should a heavy vehicle normally use?
Show answer
Answer A: The right lane, except to pass or where signs direct otherwise
Keeping right leaves the faster lanes free and reduces the number of vehicles that have to move around a slower, heavier vehicle.
-
33. Why must a bent, cracked or badly seated lock ring be reported?
Show answer
Answer D: It can come off under pressure and let the tire and rim separate violently
The lock ring holds the assembly together against the full pressure of the tire, so a damaged ring can release with enough force to kill.
-
34. On a tractor with a sliding fifth wheel, what does moving the fifth wheel forward do?
Show answer
Answer A: Puts more of the trailer weight onto the steering axle
Moving the coupling point forward transfers weight from the drive axles to the steering axle, which is how a driver corrects a drive axle that is over the limit.
-
35. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
36. What is the main purpose of a retarder fitted to a heavy vehicle?
Show answer
Answer B: To help slow the vehicle and reduce the need to use the service brakes
Exhaust, engine, hydraulic and electric retarders all slow the vehicle so the brakes stay cool and wear less, especially on grades.
-
37. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
38. Under Wisconsin's commercial license rules, what makes a combination of vehicles a Class A rig?
Show answer
Answer B: A combined weight over 26,000 pounds where the towed unit alone is rated over 10,000 pounds
Wisconsin defines Class A as any combination over 26,000 pounds GVWR, actual, or registered weight, where the towed vehicle alone is rated over 10,000 pounds.
-
39. Why should both outside mirrors be checked over and over while backing?
Show answer
Answer B: Each mirror covers only part of the path and neither covers the blind spots, so people and objects can appear without warning
Working both mirrors in turn is the only way to follow the whole path of a vehicle you cannot see behind.
-
40. How should a commercial driver treat the speed posted for a curve?
Show answer
Answer B: As a limit set for cars in good conditions, so a heavy or tall load calls for a lower speed
Posted curve speeds are based on passenger vehicles in good conditions, and a tall or heavy load can roll over well below that speed.
-
41. Why should a retarder be switched off when the road is wet, icy or snowy?
Show answer
Answer C: It can make the drive wheels skid when traction is poor
A retarder slows the drive wheels only, and on a slippery surface that braking force can break their traction and start a skid.
-
42. What is the driver responsible for when a load is covered with a tarp?
Show answer
Answer C: Fastening it so it cannot flap free, block a mirror, or come off in the wind
A tarp that works loose can tear away, block the driver view or the view of others, and become a hazard for the traffic behind.
-
43. After coupling, where should the fifth wheel release handle be?
Show answer
Answer A: In the locked position with the safety latch in place
The handle must be pushed in and latched, because a handle left out means the jaws can open and release the trailer while you are driving.
-
44. On a set of dual tires, which condition must be reported as a defect?
Show answer
Answer D: The two tires are touching each other or rubbing on part of the vehicle
Duals that touch each other or the vehicle overheat and wear quickly, so they must be separated by proper spacing and inflation before driving.
-
45. Why should the radiator cap never be removed while the engine is hot?
Show answer
Answer A: The cooling system is under pressure and scalding coolant can be sprayed out
A hot cooling system holds pressurized coolant above its normal boiling point, so releasing the cap can throw boiling liquid and steam at whoever is holding it.
-
46. Why does a driver use pull-ups while backing into a tight space?
Show answer
Answer C: To pull forward and start the approach again when the angle is going wrong
Stopping, pulling ahead and repositioning fixes a bad angle safely, and there is nothing wrong with needing more than one attempt.
-
47. A vehicle carries placards on its front, rear and both sides. What is the main purpose of those placards?
Show answer
Answer C: To tell emergency responders and other people what hazard the cargo presents
Placards warn everyone around the vehicle, especially emergency responders, about the kind of hazard the cargo presents.
-
48. Where do you find the maximum weight a tire can safely carry?
Show answer
Answer D: Stamped on the sidewall of the tire itself
Each tire is marked with the greatest weight it can carry at a stated inflation pressure, and the load on an axle must stay within the total for its tires.
-
49. What happens to braking performance if oil or grease reaches a brake lining?
Show answer
Answer B: That brake loses much of its effect and the vehicle can pull to one side
A contaminated lining cannot grip the drum, so that wheel contributes little braking and the vehicle pulls toward the side that is still working.
-
50. Which situations call for a mirror check in a commercial vehicle?
Show answer
Answer A: Every lane change, turn, merge and tight maneuver
Mirrors must be checked regularly and always before, during and after any movement that changes the path of the vehicle.